Description
2009 Chevrolet Corvette Smart Key Fob Driver 1 PN: 25926479
Extended warranty is available on the checkout page.
FCC ID: M3N-5WY7777A
Part Number: 25926480
Brand: Chevrolet
Condition: OEM New
Seat Memory: Driver 1
This remote features 4 buttons: Lock, Unlock, Panic, Trunk. This remote sends it’s signals on a frequency of 315Mhz. This remote will work for your vehicle if your vehicle is equipped with factory smart keyless entry.
Programming Procedure:
To match a new transmitter to your vehicle when you have a recognized transmitter (two recognized transmitters required for Canadian owners):
1. The vehicle must be off.
2. Have the recognized and new, unrecognized transmitters on your person.
3. Go to the rear of the vehicle and insert the vehicle key into the key cylinder located above the license plate.
4. Open the trunk.
5. Turn the key five times within five seconds.
6. The DIC will display READY FOR FOB #X, where X can be 2, 3, or 4.
7. Place the new, unrecognized transmitter in the glove box transmitter pocket with the buttons facing towards the passenger’s side.
8. Once the transmitter is programmed, a beep will sound. The DIC will display READY FOR #X, where X can be 3 or 4, or MAXIMUM NUMBER OF FOBS LEARNED.
9. Press the Acc. button (ignition switch).
The Canadian immobilizer standard requires Canadian owners to see their dealer/retailer for matching new transmitters when two recognized transmitters are not available. United States owners are permitted to match a new transmitter to their vehicle when a recognized transmitter is not available. The procedure will require three ten minute cycles to complete the matching process.
1. The vehicle must be off.
2. Place the new, unrecognized transmitters in the glove box transmitter pocket with the buttons facing towards the passenger’s side.
3. Go to the rear of the vehicle and insert the vehicle key into the key cylinder located above the license plate.
4. Open the trunk.
5. Turn the key five times within five seconds.
6. The DIC message will display OFF-ACCESSORY TO LEARN.
7. Press the Acc. button (ignition switch).
8. The DIC will read WAIT 10 MINUTES and will count down to zero, one minute at a time.
9. The DIC will display OFF-ACCESSORY TO LEARN again.
10. Press the Acc. button (ignition switch).
11. The DIC will read WAIT 10 MINUTES and will count down to zero, one minute at a time.
12. The DIC will display OFF-ACCESSORY TO LEARN again.
13. Press the Acc. button (ignition switch).
14. The DIC will read WAIT 10 MINUTES and will count down to zero, one minute at a time.
15. A beep will sound and the DIC will read READY FOR FOB #1. At this time, all previously known transmitters have been erased.
16. Once the transmitter is recognized and programmed, a beep will sound and the DIC will display READY FOR FOB #2.
If you have additional transmitter to program, take transmitter 1 out of the transmitter pocket and place transmitter 2 in the pocket. This can be done repeatedly until up to four transmitters have been programmed. the DIC will then display MAXIMUM NUMBER OF FOBS LEARNED and will exit the programming mode.
When you are done programming transmitters. press the Acc button (ignition switch).
The following vehicles can use this remote when equipped with the factory keyless entry system:
Chevrolet Corvette (2008-2013)