Description
2007 Honda Fit Remote PN: 08E61-S5D-1M001
We test the remote when it arrives at our facility, when we put it in stock, and when we put your order together. Being tested three times means you can be relatively sure you are going to receive a remote that is sending the appropriate signals and will be accepted by the car.
Remote For Honda:
The FCC ID of the remote you will receive is NHVWB1U523. It can be used to replace the discontinued FCC ID NHVWB1U521. This remote is used on the Accord, Civic, and Element when they have the system that uses this remote. Vehicles that use this remote are easy to program using the programming procedure included with the purchase. Also, we provide free tech support over the phone to assist you if needed. This listing is for a brand new remote – not a used one. This remote is a genuine honda remote, not a generic replacement. This remote has three buttons: LOCK, UNLOCK, and PANIC. The LOCK and UNLOCK buttons send a signal right away when you press the buttons. By design, the PANIC button must be pressed for almost 2 seconds to product a signal. If you have an old remote for your car and the FCC ID on the back of it is the same as NHVWB1U523 or NHVWB1U521 then you can be sure this remote will work for you.
Programming Procedure:
IMPORTANT: Entering the programming mode cancels all learned remote codes, so no previously programmed remotes will work. You must program all remotes, including existing ones now. Separate your ignition key from remotes on keychain.
1. Start with your key in your right hand and any remote in your left hand. Keep all additional remotes easily accessible to your left hand. Insert the key into the ignition.
2. Perform these steps within 5 seconds.
a. Turn the ignition to the ON position (where the instrument panel lights are turned on without starting the engine.)
b. Press the UNLOCK button on the remote and release.
c. Turn the ignition back to LOCK (the position where the key is inserted) and leave the key in the ignition.
d. Turn the ignition to the ON position (where the instrument panel lights are turned on without starting the engine.)
e. Press the UNLOCK button on the remote and release.
f. Turn the ignition back to LOCK (the position where the key is inserted) and leave the key in the ignition.
g. Turn the ignition to the ON position (where the instrument panel lights are turned on without starting the engine.)
h. Press the UNLOCK button on the remote and release.
i. Turn the ignition back to LOCK (the position where the key is inserted) and leave the key in the ignition.
3. Within 5 seconds turn the ignition to ON.
4. Press the UNLOCK button on the same remote and release. The power door locks will cycle to confirm the system is in programming mode.
5. Within 10 seconds press the UNLOCK button on the same remote again and release. The door locks will cycle to confirm that the system accepted this remote.
6. Repeat step 5 for second or third remotes.
7. Turn the key back to LOCK and remove from ignition to exit programming mode.
The following vehicles can use this remote when equipped with the factory keyless entry system:
Honda Accord (2003-2004) – DX, Honda Civic (2001), Honda Civic (2002-2005), Honda Element (2003), Honda Element (2004-2006) – DX/LX, Honda Fit (2007-2008) – Base, Honda Pilot (2003-2004) – EX.
