Description
1998 Lincoln Mark VIII Remote FCC ID: LHJ002
The FCC ID of these remotes is LHJ002. There was a version without seat memory and a version with seat memory which came in driver 1 and driver 2 versions. The LHJ002 Dogbone remotes were discontinued by Ford and replaced by the square grey remote (3040A replaces 3080A, 3041A replaces 3081A, 3042A replaces 3082A).
Remote For Lincoln:
This remote has 4 buttons and sends it’s signals on a frequency of 315 MHz. We test the remotes on keyless entry testers to ensure they work before sending to you. We have free tech support for programming the remote to your vehicle.
Programming Procedure:
For 1999-2002 Continental:
1. Insert the keys in the ignition and turn the ignition switch from OFF to RUN, up to eight times within ten seconds, ending in OFF. When the vehicle has successfully entered programming mode, it will lock and then unlock all door locks automatically. (Note: The RUN position is as far as you can turn the key without cranking the engine. If the door locks do not cycle indicating programming mode has been entered, try the procedure without doing step 1 and having the driver door closed. If you still can?? get into programming mode after trying this numerous times both ways then you either do not have the factory keyless entry system or it is not functioning properly. In many vehicles you should end in the RUN position and not the OFF position. If you have anti-theft deterrent then before doing this step you should open the driver door and cycle the power door locks twice. This means you press LOCK, UNLOCK, LOCK, UNLOCK. Step ones says to turn from OFF to RUN up to eight times. If the locks cycle before eight times then move onto step 2 immediately. Do not continue cycling the ignition switch.)
2. Within 15 seconds, press ANY button on a keyless entry remote transmitter. The doors will lock and then unlock to confirm that each keyless entry remote transmitter has been activated. (Note: When the first keyless entry remote transmitter is programmed, all existing keyless entry remote transmitters are erased.)
3. Repeat step 2 immediately for each transmitter that will operate the vehicle including your old ones (if any.)
4. If the door locks do not respond for any keyless entry remote transmitter, wait 10 seconds and press the button again.
5. Turn the ignition switch to the OFF position or wait up to 30 seconds after step 2, to exit program mode. If a keyless entry remote transmitter has been activated, the vehicle may lock and unlock all doors one last time to confirm.
For 1997-1998 Mark VIII and 1995-1998 Continental:
1. Enter the five-digit permanent code into the keyless entry keypad. The code is typically written in the owner?? manual, printed on the code card. It may also be printed on a sticker in the trunk on the underside of the trunk lid or on the trunk lid support. If you can not find it the Dealer can provide it from the VIN number.
2. Within five seconds press 1/2 button.
3. Within five seconds, press and hold any button on the first remote until the locks cycle to confirm programming success.
4. Within five seconds press any button on a second remote if you have. Repeat this for all additional remotes including the old ones. You can program up to four.
5. Press 7/8 and 9/0 together to end programming mode.
The following vehicles can use this remote when equipped with the factory keyless entry system:
Lincoln Continental (1995-1998), Lincoln Continental (1999-2002), Lincoln Mark VIII (1997-1998), Lincoln Mark VIII (1997-1998).
