Description
1998 BMW 323i Remote 88036-AE060 88035-AC231 88036-XA010 A269ZUA111
All vehicles that use this remote are onboard programmable, meaning you can program the vehicle to accept new remotes yourself without any special tools or knowledge. Free phone tech support is available if needed.
Remote for Subaru and BMW:
This remote features 2 buttons. This will work for your vehicle when equpped with factory keyless entry system. It has an FCC ID: A269ZUA111 and Part numbers: 88036-AE060, 88035-AC231, 88036-XA010.
Programming Procedure:
- For 1996-2000 BMW Z3, 1998-1999 BMW M Roadster, 1996-1997 BMW M Coupe, 1996-1999 BMW 328IS, 1996-2000 BMW 328I, 1996-2000 BMW 325I, 1998-2000 BMW 323IS, 1998-2000 BMW 323I, 2000 BMW 323CI, 1996-1999 BMW 318TI, 1996-1997 BMW 318IS and 1996-1998 BMW 318I.
1. Step out of the vehicle. Make sure all the doors, trunk, and hood are closed. The security system must be in the disarmed condition. The key should not be in the ignition. Perform step 2-4 within 45 seconds.
2. Open the trunk and leave it open.
3. Open the driver door and sit in driver seat.
4. Close driver door.
5. Cycle the ignition 5 times within 10 seconds between OFF and ON (as far as it goes without cranking engine). The red security LED will light up and the siren will chirp once to indicate programming mode has been engaged.
6. Open the driver door and remain seated in the driver seat.
7. Close the driver door.
8. Press and release any button on the remote you want to program. The LED will shut off momentarily to indicate that the remote has been learned.
9. Repeat steps 6 to 8 to program additional remotes including your old remotes.
10. Open the driver door and exit the vehicle, leaving the door open.
11. Close the trunk.
12. Close the driver door. The LED will turn off and the siren will chirp twice.
- For 1999-2004 Subaru Legacy/Outback, 2001-2004 Subaru Impreza, 2001-2004 Subaru Forester and 2003-2006 Subaru Baja.
Note: Perform steps 1-4 within 45 seconds.
1. Sit in the driver?? seat and close all doors, rear gate and trunk lid.
2. Open the driver?? door.
3. Close the door.
4. Insert keys in ignition. Turn the ignition switch from LOCK to ON (as far as you can go without cranking the engine) ten times in rapid succession (within 15 seconds), ending in LOCK. The horn chirps once to indicate that the system has entered programming mode.
5. Open the driver?? door.
6. Close the driver?? door
7. Press any button on the transmitter you wish to program top the system. The horn will chirp two times to indicate that the transmitter has been programmed.
8. Any additional transmitters can also be programmed at this time (including your old ones.) Repeat steps 5 through 7 for each additional transmitter.
9. Remove the ignition key from the ignition switch. The horn will chirp three times to indicate system is out of programming mode.
