1993 Mercury Sable Remote PN: F5DZ-15K601-B Hot on Sale

$35.98

Clear
SKU: US-7652267786434 Categories: ,
Description

Description

1993 Mercury Sable Remote PN: F5DZ-15K601-B


 All automobiles that use this remote are onboard programmable. This indicates that you can program the car to accept new remotes yourself without using special tools or having special knowledge. Free phone tech support is available if you need it.


 Remote For Ford Mercury Lincoln:

This remote features 4 buttons: Lock, Unlock, Trunk, and Panic. This remote sends it’s signals on a frequency of 315Mhz. This remote will work for your vehicle if your vehicle is equipped with factory keyless entry. This is a replacement for the factory keyless entry remote on many Ford, Mercury, and Lincoln vehicles. This remote replaces the following FCC ID: GQ43VT4T. There ford part number is F5DZ-15K601-B. The remote is tested before shipping to make sure you are sent a remote that is sending the correct signals and has proper strength.


Programming Procedure:

  • For 1997-1998 Tracer, 1996-1997 Sable, 1996-1997 Taurus, 1997-1998 Escort:

1. Insert the keys in the ignition and turn the ignition switch from OFF to RUN, up to eight times within ten seconds, ending in OFF. When the vehicle has successfully entered programming mode, it will lock and then unlock all door locks automatically.
(Note: The RUN position is as far as you can turn the key without cranking the engine. If the door locks do not cycle indicating programming mode has been entered, try the procedure without doing step 1 and having the driver door closed. If you still can’t get into programming mode after trying this numerous times both ways then you either do not have the factory keyless entry system or it is not functioning properly. In many vehicles you should end in the RUN position and not the OFF position. If you have anti-theft deterrent then before doing this step you should open the driver door and cycle the power door locks twice. This means you press LOCK, UNLOCK, LOCK, UNLOCK. Step ones says to turn from OFF to RUN up to eight times. If the locks cycle before eight times then move onto step 2 immediately. Do not continue cycling the ignition switch.)
2. Within 15 seconds, press ANY button on a keyless entry remote transmitter. The doors will lock and then unlock to confirm that each keyless entry remote transmitter has been activated.
(Note: When the first keyless entry remote transmitter is programmed, all existing keyless entry remote transmitters are erased.)
3. Repeat step 2 immediately for each transmitter that will operate the vehicle including your old ones (if any.)
4. If the door locks do not respond for any keyless entry remote transmitter, wait 10 seconds and press the button again.
5. Turn the ignition switch to the OFF position or wait up to 30 seconds after step 2, to exit program mode. If a keyless entry remote transmitter has been activated, the vehicle may lock and unlock all doors one last time to confirm.


  • For 1993-1994 Grand Marquis, 1993-1994 Town Car, 1993-1996 Mark VIII, 1993-1994 Continental, 1994-1996 Mustang, 1993-1994 Crown Victoria, 1995-2000 Contour:

Note: The programming connector is located behind/under the glove compartment (attached to the relay mounting panel or taped to the wire assembly) and is accessed by dropping the glove compartment. It’s a white or light gray plastic connector with two terminals that is not plugged into anything. The color of the two wires leading to the plastic connector is grey/yellow and white/yellow.
1. Put the ignition to ON or ACC and momentarily jump the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors or chirping the horn. After that, remove the jumper wire.
2. Press any button on the first remote. All doors will lock and unlock or horn will chirp to verify programming of that remote.
3. Press any button on each additional remotes (including your old ones) allowing a pause for the door locks to cycle after each remote. The keyless entry system will allow up to four remotes to be programmed.
4. Turn the ignition to OFF. All doors will lock then unlock or the horn will chirp.


  • For 1993-1995 Sable, 1993-1997 Thunderbird, 1993-1995 Taurus, 1996 Mustang:

Note: The programming connector is located in the trunk on the driver’s side behind the trim panel. It is taped to a wiring harness going to the rear tail light. It’s a white or light gray plastic connector with two terminals that are not plugged into anything.
1. Put the ignition to RUN or ACC and momentarily jump the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors.
2. Press any button on the first remote. All doors will lock and unlock or the horn will chirp to verify programming of that remote.
3. Press any button on each additional remotes (including your old ones) allowing a pause for the door locks to cycle after each remote. The keyless entry system will allow up to four remotes to be programmed.
4. Turn the ignition to OFF. All doors will lock then unlock or the horn will chirp.


  • For 1993-1997 Cougar, 1997-1998 Mustang:

NOTE: The program connector is located in the trunk, behind the rear left hand side access panel, taped to the wiring harness between the left tail light and the rear left wheel well. It is a plastic connector that is NOT plugged into anything.
1. Put the ignition switch in RUNor ACC and momentarily jumper the two program connecter terminals with a suitable jumper wire. The system will respond by locking and unlocking all of the doors.
2. Press any button on the transmitter. All doors will lock and then unlock to verify transmitter signal acceptance.
3. Repeat step 2 for each transmitter (including your old ones) in order to program the remote keyless entry module to accept up to four transmitter signals.
4. Turn the ignition switch to OFF All of the doors will then lock and unlock.


  • For 1993-1997 Probe:

Note: The programming connector is located in the trunk on the passenger’s side behind the trim panel. It is taped to a wiring harness going to the rear tail light. It’s a white or light gray plastic connector with two terminals that is not plugged into anything.
1. Put the ignition to ON or ACC and momentarily jump the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors.
2. Press any button on the first remote. All doors will lock and unlock or the horn will chirp to verify programming of that remote.
3. Press any button on each additional remotes (including your old ones) allowing a pause for the door locks to cycle after each remote. The keyless entry system will allow up to four remotes to be programmed.
4. Turn the ignition to OFF. All doors will lock then unlock or the horn will chirp.


  • For 1995-2000 Mistique:

Note: The programming connector is located behind/under the glove compartment (attached to the relay mounting panel or taped to the wire assembly) and is accessed by dropping the glove compartment. It’s a white or light gray plastic connector with two terminals that is not plugged into anything. The color of the two wires leading to the plastic connector is grey/yellow and white/yellow.
1. Put the ignition to ON or ACC and momentarily jump the two program connector terminals with a suitable jumper wire. The system will respond by locking and then unlocking all doors or chirping the horn. After that, remove the jumper wire.
2. Press any button on the first remote. All doors will lock and unlock or horn will chirp to verify programming of that remote.
3. Press any button on each additional remotes (including your old ones) allowing a pause for the door locks to cycle after each remote. The keyless entry system will allow up to four remotes to be programmed.
4. Turn the ignition to OFF. All doors will lock then unlock or the horn will chirp.


The following vehicles can use this remote when equipped with the factory keyless entry system:

Mercury Tracer (1997-1998), Ford Contour (1995-2000), Ford Crown Victoria (1993-1994), Ford Escort, (1997-1998), Ford Mustang (1994-1998), Ford Probe (1993-1997), Ford Taurus (1993-1997), Ford Thunderbird (1993-1997), Lincoln Continental (1993-1994), Lincoln Mark VIII (1993-1996), Lincoln Town Car (1993-1994), Mercury Cougar (1993-1997), Mercury Grand Marquis (1993-1994), Mercury Mystique (1995-2000), Mercury Sable (1993-1997), Mercury Tracer (1997-1998), Ford Crown Victoria (1993-1994), Ford Escort (1997-1998), Ford Mustang (1994-1998), Ford Probe (1993-1997), Ford Taurus (1993-1997), Ford Thunderbird (1993-1997), Lincoln Continental (1993-1994), Lincoln Mark VIII (1993-1996), Lincoln Town Car (1993-1994), Mercury Cougar (1993-1997), Mercury Grand Marquis (1993-1994), Mercury Mystique (1995-2000), Mercury Sable (1993-1997).

Additional information

Additional information

Condition

OEM New, OEM Refurbished, Replacement New

Shipping & Delivery

We accept returns on non-sale items that are in original packaging, unused, and unwashed within 30 days of receipt. Please follow our returns/exchanges process below. If items do not meet our requirements for return, they will be shipped back to you in lieu of a refund. Shipping and handling charges are non-refundable (exceptions may apply).

Returns & Exchanges Process: If item(s) fit within our returns guidelines found in the Returns. Please allow 7-10 business days for the credit to appear on your account after your return is processed.